Systyem nie rozpoznaje skanera Plustek S28
: 01 cze 2009, 15:05
Tak jak w temacie. Z firmowej pomocy technicznej wiem że nie ma sterowników do tego modelu pod Linuxa. Na forum znalazłem tylko coś takiego:
http://www.ubucentrum.net/2008/03/insta ... xsane.html
a na to konsola:
# sane-find-scanner will now attempt to detect your scanner. If the
# result is different from what you expected, first make sure your
# scanner is powered up and properly connected to your computer.
# No SCSI scanners found. If you expected something different, make sure that
# you have loaded a kernel SCSI driver for your SCSI adapter.
found USB scanner (vendor=0x07b3 [PLUSTEK INC], product=0x0801 [USB2.0 SCANNER], chip=GL842) at libusb:001:004
# Your USB scanner was (probably) detected. It may or may not be supported by
# SANE. Try scanimage -L and read the backend's manpage.
# Not checking for parallel port scanners.
# Most Scanners connected to the parallel port or other proprietary ports
# can't be detected by this program.
desktop ~/Pulpit $ scanimage -L
No scanners were identified. If you were expecting something different,
check that the scanner is plugged in, turned on and detected by the
sane-find-scanner tool (if appropriate). Please read the documentation
which came with this software (README, FAQ, manpages).
Proszę o pomoc.
http://www.ubucentrum.net/2008/03/insta ... xsane.html
a na to konsola:
# sane-find-scanner will now attempt to detect your scanner. If the
# result is different from what you expected, first make sure your
# scanner is powered up and properly connected to your computer.
# No SCSI scanners found. If you expected something different, make sure that
# you have loaded a kernel SCSI driver for your SCSI adapter.
found USB scanner (vendor=0x07b3 [PLUSTEK INC], product=0x0801 [USB2.0 SCANNER], chip=GL842) at libusb:001:004
# Your USB scanner was (probably) detected. It may or may not be supported by
# SANE. Try scanimage -L and read the backend's manpage.
# Not checking for parallel port scanners.
# Most Scanners connected to the parallel port or other proprietary ports
# can't be detected by this program.
desktop ~/Pulpit $ scanimage -L
No scanners were identified. If you were expecting something different,
check that the scanner is plugged in, turned on and detected by the
sane-find-scanner tool (if appropriate). Please read the documentation
which came with this software (README, FAQ, manpages).
Proszę o pomoc.