Witam ! Wczoraj, niechcący rozwiązałem problem, mianowicie idąc za Twoją sugestią odinstalowałem WICD zamieniając go ponownie na network managera, i korzystając z szybkiego internetu w pracy zaktualizowałem wszystko co się dało, poza samym jądrem. Poaktualizacji ku mojemu zdumieniu połączył sie z wifi :O
Dla celów kształcących mimo wszystko podaje wyniki komend które zasugerowałeś. Dziękuję również za ŧwą pomoc !
Kod: Zaznacz cały
2:02.0 Network controller: Intersil Corporation ISL3886 [Prism Javelin/Prism Xbow] (rev 01)
Subsystem: Intersil Corporation Device 0000
Kernel driver in use: p54pci
Kernel modules: p54pci, prism54
edwin@edwin-AMILO-PRO-V7010:~$
Kod: Zaznacz cały
edwin@edwin-AMILO-PRO-V7010:~$ dmesg | grep 54
[ 0.000000] [<c178f540>] ? start_kernel+0xbe/0x366
[ 0.000000] Memory: 461360k/490496k available (5192k kernel code, 28684k reserved, 2544k data, 700k init, 0k highmem)
[ 0.000000] .data : 0xc1512191 - 0xc178e4c0 (2544 kB)
[ 0.004954] ns_cgroup deprecated: consider using the 'clone_children' flag without the ns_cgroup.
[ 0.017547] ACPI: Core revision 20110112
[ 0.056003] ..MP-BIOS bug: 8254 timer not connected to IO-APIC
[ 0.254428] ACPI: Dynamic OEM Table Load:
[ 0.254445] ACPI: SSDT (null) 002B0 (v01 PmRef Cpu0Ist 00003000 INTL 20030224)
[ 0.255402] ACPI: SSDT 1df76035 0021B (v01 PmRef Cpu0Cst 00003001 INTL 20030224)
[ 0.260542] ACPI: SSDT (null) 00066 (v01 PmRef Cpu1Cst 00003000 INTL 20030224)
[ 0.305430] pci 0000:00:01.0: [1002:5838] type 1 class 0x000604
[ 0.308687] pci 0000:02:01.0: [104c:ac54] type 2 class 0x000607
[ 0.308902] pci 0000:02:01.1: [104c:ac54] type 2 class 0x000607
[ 0.380542] pnp 00:07: [io 0x0cd6-0x0cd7]
[ 0.435404] pci 0000:02:01.0: BAR 14: assigned [io 0xa400-0xa4ff]
[ 0.435420] pci 0000:02:01.1: BAR 13: assigned [io 0xa800-0xa8ff]
[ 0.435435] pci 0000:02:01.1: BAR 14: assigned [io 0xac00-0xacff]
[ 0.435447] pci 0000:02:01.0: CardBus bridge to [bus 03-06]
[ 0.435462] pci 0000:02:01.0: bridge window [io 0xa000-0xa0ff]
[ 0.435483] pci 0000:02:01.0: bridge window [io 0xa400-0xa4ff]
[ 0.435542] pci 0000:02:01.1: CardBus bridge to [bus 07-0a]
[ 1.154045] input: Power Button as /devices/LNXSYSTM:00/LNXPWRBN:00/input/input1
[ 1.154067] ACPI: Power Button [PWRF]
[ 1.154680] ACPI: acpi_idle registered with cpuidle
[ 1.254833] ACPI: Deprecated procfs I/F for battery is loaded, please retry with CONFIG_ACPI_PROCFS_POWER cleared
[ 1.254876] ACPI: Battery Slot [BAT0] (battery present)
[ 2.040548] brd: module loaded
[ 2.056954] ohci_hcd 0000:00:13.0: irq 19, io mem 0xf0001000
[ 3.187549] mousedev: PS/2 mouse device common for all mice
[ 3.189541] device-mapper: multipath: version 1.2.0 loaded
[ 33.544117] shpchp: Standard Hot Plug PCI Controller Driver version: 0.4
[ 33.544543] type=1400 audit(1345299120.841:4): apparmor="STATUS" operation="profile_load" name="/usr/lib/connman/scripts/dhclient-script" pid=418 comm="apparmor_parser"
[ 34.465543] ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 35.948854] yenta_cardbus 0000:02:01.1: Using CSCINT to route CSC interrupts to PCI
[ 35.986542] type=1400 audit(1345299123.281:5): apparmor="STATUS" operation="profile_load" name="/usr/share/gdm/guest-session/Xsession" pid=579 comm="apparmor_parser"
[ 37.354132] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x3e0-0x4ff: excluding 0x3f0-0x3f7 0x408-0x40f 0x4d0-0x4d7
[ 38.976461] p54pci 0000:02:02.0: PCI INT A -> GSI 19 (level, low) -> IRQ 19
[ 39.114337] ieee80211 phy0: p54 detected a LM86 firmware
[ 39.114359] p54: rx_mtu reduced from 3240 to 2376
[ 39.535401] [drm] radeon: irq initialized.
[ 39.548134] [drm] Detected VRAM RAM=32M, BAR=64M
[ 39.548156] [drm] RAM width 64bits DDR
[ 40.179544] cfg80211: Updating information on frequency 2467 MHz for a 20 MHz width channel with regulatory rule:
[ 40.349239] Registered led device: p54-phy0::assoc
[ 40.349547] Registered led device: p54-phy0::tx
[ 40.349859] Registered led device: p54-phy0::rx
[ 40.350138] Registered led device: p54-phy0::radio
[ 40.350179] p54pci 0000:02:02.0: is registered as 'phy0'
[ 92.655447] wlan0: deauthenticating from 06:27:22:53:8a:be by local choice (reason=3)
[ 92.708549] cfg80211: 2402000 KHz - 2472000 KHz @ KHz), (300 mBi, 2000 mBm)
[ 222.954994] cfg80211: Updating information on frequency 2412 MHz for a 20 MHz width channel with regulatory rule:
[ 233.854290] ATI IXP AC97 controller 0000:00:14.5: PCI INT B disabled
[ 233.854685] ehci_hcd 0000:00:13.2: PCI INT A disabled
[ 233.854714] ohci_hcd 0000:00:13.1: PCI INT A disabled
[ 233.854741] ohci_hcd 0000:00:13.0: PCI INT A disabled
[ 236.400824] PM: suspend of drv:pata_atiixp dev:0000:00:14.1 complete after 2546.309 msecs
[ 236.400841] PM: suspend of drv: dev:pci0000:00 complete after 2545.893 msecs
[ 237.512546] pci 0000:00:14.6: restoring config space at offset 0x1 (was 0x4200017, writing 0x4200013)
[ 237.512654] b44 0000:02:00.0: restoring config space at offset 0x1 (was 0x100000, writing 0x8100006)
[ 237.513065] p54pci 0000:02:02.0: restoring config space at offset 0xf (was 0x1c0a0100, writing 0x1c0a010b)
[ 237.513092] p54pci 0000:02:02.0: restoring config space at offset 0x4 (was 0x0, writing 0xf0202000)
[ 237.513101] p54pci 0000:02:02.0: restoring config space at offset 0x3 (was 0x0, writing 0x5008)
[ 237.513111] p54pci 0000:02:02.0: restoring config space at offset 0x1 (was 0x2980000, writing 0x2980016)
[ 249.349554] cfg80211: 2402000 KHz - 2482000 KHz @ KHz), (N/A mBi, 2000 mBm)
[ 249.349854] cfg80211: 2402000 KHz - 2482000 KHz @ KHz), (N/A mBi, 2000 mBm)
[ 249.349953] cfg80211: (5490000 KHz - 5710000 KHz @ 40000 KHz), (N/A, 2700 mBm)
edwin@edwin-AMILO-PRO-V7010:~$
Z góry dziękuję .Pozdrawiam
//bear7: Zgodnie z regulaminem, to temat na osobny wątek, ale wpisz kolego w terminalu man grep i/albo man dmsg, to dowiesz się do czego służą.
//k2cl: ja ze swojej strony dodam, że komenda "dmsg" nie istnieje 
o grepie i "|" możesz dowiedzieć się czegoś chociażby z artykułów w Czytelni, tworzonych pod wspólnym szyldem "konsola nie gryzie".