To mi pokazuje w konsoli po najprostszych próbach.
Kod: Zaznacz cały
renal@Renal:~$ dmesg|tail -30
[ 607.473447] wlp2s0: send auth to 2c:5d:93:a0:7b:98 (try 1/3)
[ 607.475050] wlp2s0: authenticated
[ 607.477998] wlp2s0: associate with 2c:5d:93:a0:7b:98 (try 1/3)
[ 607.484777] wlp2s0: RX AssocResp from 2c:5d:93:a0:7b:98 (capab=0x431 status=0 aid=17)
[ 607.486183] wlp2s0: associated
[ 727.613649] wlp2s0: disconnect from AP 2c:5d:93:a0:7b:98 for new auth to 2c:5d:93:a0:7b:9c
[ 727.620907] wlp2s0: authenticate with 2c:5d:93:a0:7b:9c
[ 727.626945] wlp2s0: send auth to 2c:5d:93:a0:7b:9c (try 1/3)
[ 727.627532] wlp2s0: authenticated
[ 727.628451] wlp2s0: associate with 2c:5d:93:a0:7b:9c (try 1/3)
[ 727.633582] wlp2s0: RX AssocResp from 2c:5d:93:a0:7b:9c (capab=0x411 status=0 aid=4)
[ 727.634991] wlp2s0: associated
[ 727.699772] wlp2s0: Limiting TX power to 30 (30 - 0) dBm as advertised by 2c:5d:93:a0:7b:9c
[ 763.050579] usb 1-3: USB disconnect, device number 7
[ 779.153729] usb 1-2: new high-speed USB device number 8 using xhci_hcd
[ 779.295903] usb 1-2: New USB device found, idVendor=1221, idProduct=3234
[ 779.295907] usb 1-2: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[ 779.295910] usb 1-2: Product: USB Disk
[ 779.295912] usb 1-2: Manufacturer: Flash
[ 779.295914] usb 1-2: SerialNumber: 3727013FB7E3275710617
[ 779.296612] usb-storage 1-2:1.0: USB Mass Storage device detected
[ 779.297979] scsi host4: usb-storage 1-2:1.0
[ 780.310554] scsi 4:0:0:0: Direct-Access Flash USB Disk 2.F0 PQ: 0 ANSI: 2
[ 780.311444] sd 4:0:0:0: Attached scsi generic sg1 type 0
[ 780.311710] sd 4:0:0:0: [sdb] 15728640 512-byte logical blocks: (8.05 GB/7.50 GiB)
[ 780.311860] sd 4:0:0:0: [sdb] Write Protect is on
[ 780.311864] sd 4:0:0:0: [sdb] Mode Sense: 0b 00 80 08
[ 780.311981] sd 4:0:0:0: [sdb] No Caching mode page found
[ 780.311988] sd 4:0:0:0: [sdb] Assuming drive cache: write through
[ 780.332882] sd 4:0:0:0: [sdb] Attached SCSI removable disk
renal@Renal:~$ sudo mount /dev/sdb /mnt
mount: /dev/sdb is write-protected, mounting read-only
mount: wrong fs type, bad option, bad superblock on /dev/sdb,
missing codepage or helper program, or other error
In some cases useful info is found in syslog - try
dmesg | tail or so.
renal@Renal:~$ sudo fdisk -l
Disk /dev/sda: 931,5 GiB, 1000204886016 bytes, 1953525168 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 4096 bytes
I/O size (minimum/optimal): 4096 bytes / 4096 bytes
Disklabel type: gpt
Disk identifier: F89B7E3F-5D25-440B-9E94-D29EF3E95DFC
Urządzenie Start Koniec Sektory Size Typ
/dev/sda1 2048 534527 532480 260M EFI System
/dev/sda2 534528 567295 32768 16M Microsoft reserved
/dev/sda3 567296 1474577855 1474010560 702,9G Microsoft basic data
/dev/sda4 1869402112 1921830911 52428800 25G Microsoft basic data
/dev/sda5 1921830912 1923878911 2048000 1000M Windows recovery environment
/dev/sda6 1923878912 1951475711 27596800 13,2G Windows recovery environment
/dev/sda7 1951475712 1953523711 2048000 1000M Lenovo boot partition
/dev/sda8 1474578432 1853046783 378468352 180,5G Linux filesystem
/dev/sda9 1853046784 1869402111 16355328 7,8G Linux swap
Partition table entries are not in disk order.
Disk /dev/sdb: 7,5 GiB, 8053063680 bytes, 15728640 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 512 bytes / 512 bytes