Nie wiem czy to pomoże ale w twoim wvdial.conf brak jest komendy ATD
Kod: Zaznacz cały
Phone = ATD*99***1#
Kod: Zaznacz cały
Phone = ATD*99***1#
Kod: Zaznacz cały
Searching for DUN on 00:23:39:71:D8:BB ...
Service Name: Dialup Networking
Service RecHandle: 0x10003
Service Class ID List:
"Dialup Networking" (0x1103)
Protocol Descriptor List:
"L2CAP" (0x0100)
"RFCOMM" (0x0003)
Channel: 3
Profile Descriptor List:
"Dialup Networking" (0x1103)
Version: 0x0100
Kod: Zaznacz cały
rfcomm0 {
bind yes;
device 00:23:39:71:D8:BB;
channel 3;
comment "BT U800 dial-up";
}
Kod: Zaznacz cały
rfcomm0: 00:23:39:71:D8:BB channel 3 clean
Kod: Zaznacz cały
[Dialer Defaults]
Modem = /dev/rfcomm0
Baud = 57600
Init1 = ATH
Init2 = ATE1
Init3 = AT+CGDCONT=1,"IP","www.plusgsm.pl"
Dial Command = ATD
Phone=*99***1#
Username = plusgsm
Password = plusgsm
Kod: Zaznacz cały
--> WvDial: Internet dialer version 1.60
--> Cannot get information for serial port.
--> Initializing modem.
--> Sending: ATH
ATH
ERROR
--> Bad init string.
--> Cannot open /dev/rfcomm0: Input/output error
Użytkownicy przeglądający to forum: Obecnie na forum nie ma żadnego zarejestrowanego użytkownika i 10 gości